Four Rivet Padlock Staple - LARGER

$30.00


Ready to have some fun? Try adding one of these to your leather straps. They can fit on any size cuff or collar with at least a 1" wide strap.

Will be added after the buckle. Your straps will have oblong holes cut to fit easily over this U-shaped staple.

Uses any padlock, so provide your own. Maximum padlock shackle thickness is 3/8ths of an inch. You can also pass rope (width up to 3/8ths of an inch) through this staple.

This post is ideal for collars. On Cuffs, the flat plate will cause "squaring" underneath the plate (plate is flat, 1 3/4 inches long). But on any collar over 14 inches in size, this flatness is not an issue. This post is installed near the end of the strap, right past the keeper loop.

Please keep in mind: this restraint is primarily decorative. Never tie someone up against their will. If they want out, get the key to the lock, or have a scissors ready to cut the strap!

This item is the #4 in the photo below, to give you a comparative idea on size. It's the largest restraint closure I have available. Plate base is 1 inch by 1.75 inches.

If you prefer this staple plate be installed vertically, it can also be used on cuffs - but the outer strap needs to be at least 1.75 inches wide. Staple dimensions: outside is 3/4", inside is 7/16", 3/16" thick, height from the plate is 13/16", plate base is 1/16" thick.


Add to Cart:



Customers who bought this product also purchased...


Your IP Address is: 54.145.16.43
Copyright © 2017 buylagarto.com. Powered by Zen Cart